Now most of the notebook computers have built-in camera, although less than in several areas such as
ACER ASPIRE 1300 battery, but its convenience is still a lot of surprises for users. But there are many users in their daily use of a good time to pay no attention to the protection of its own camera, resulting in a lot of damage to camera. In fact, using a laptop as long as the day-to-day when attention to a number of subtle ways to maintain a good notebook on camera
Camera for everyday use, the following points should be noted that attention to ensure good camera notebook:
1. Do not point the camera directly sunlight and other bright light, so as not to damage the camera's image sensor device.
2. To avoid the camera lens and oil, steam, water vapor, moisture and dust and other substances to avoid direct contact with water.
3. Do not use detergents or stimulating organic solvents to clean the camera. Best not to remove the protection of the protective film camera.
4. Non-essential circumstances, should not arbitrarily open the camera, trying to touch its internal parts, so easy to cause damage to the camera.
5. Notebook camera even comes with
Compaq Presario V4000 Battery, pay attention to drive backup software.
Common types of notebook camera introduced: http://nb.pcw.com.cn/knowledge/2009-05-31/1243746773d152048.shtml
If your camera can not be used there or not driven, the notebook can go the official forum to download, or choose camera universal driver to give it a try.
Camera Ten Frequently Asked Questions and solutions
Many of the early notebooks and cameras were not equipped with, many of my friends have chosen a USB interface external camera, following this we will look at camera looking at common problems and solutions, built-in notebook camera software in the face of question can also refer to.
Q1 not detected my computer camera?
A: check the operating system, BIOS, USB interface and installation is wrong or not.
To resolve these steps:
The first step: If your operating system is Windows 95, upgrade to Windows 98 and above, as Windows95 does not support the USB interface.
The second step: check the BIOS Setup, so that USB devices effectively.
If the settings are correct, or can not connect to camera, to try to connect the camera to the second USB interface.
If it does not work, you may install the wrong driver or choose the wrong equipment, please view the system and re-install the correct driver, the steps are as follows (in windows XP as an example):
In the "Control Panel" - "Administrative Tools" - "Computer Management" - "Device Manager", double-click the "other equipment" to view the content. Select the "unknown device" (Unknown Device) and click "delete" (Remove) button, then click "Update" (Refresh), the system will find a new equipment, follow the installation steps to re-install the camera driver.
Description: This is a rather complex issue and the need for multiple attempts.
Q2 my camera color deviations occur, how should I do?
A: Please refer to the use of the camera to adjust the video capture software programs associated with the color settings.
Q3 I have a video preview of the image color is not correct, how should I do? In other words, the video camera preview image colors do not quite normal, like the displays used for many years, the color began to abnormal after a period of time can be good.
A: Please wait for 20 to 30 seconds, let
acer aspire 5500 batteryto balance or correct. Note: For an ordinary video camera, the need for manual transfer of white, each time before shooting, must have held white, waiting to transfer white cameras. Camera also has such a process.
Q4 preview my camera is too slow, how do? Bought the camera back, after the installation of the Internet, feel the show is slow, the replacement of over ISP, replaced a number of Internet dial-up locations, the effect is very slow.
A: computer hardware upgrade. Description: view of the above, the computer performance is likely to be too low, please replace the graphics card, if not enough, upgrade CPU and motherboard, or even replace the new computer. Because the update of individual parts, performance parts vulnerable to an old constraints.
Q5 Internet, I used the camera, but found that the display of the camera is too slow, how do?
A: Internet access or a place for another ISP. If you are now at home online, there has been such a problem, you may wish to bring cameras for a place (for example: Office) online. If in the office do not have this problem, it is your speed is too slow at home, please contact the network service provider. Internet access in the office if the speed is very slow, please refer to the previous Q4.
Q6 my video camera pre-marked too bright or too dark images, the quality problem?
A: No, please adjust the brightness and contrast to the background. For further information, please refer to specification in the section on the software settings. Note: You can also use the environment and the intake from the start object, such as the removal of bright light sources or to increase the brightness of such objects.
Q7 camera when using??, how should I do?
A: check the camera driver and match camera models. In addition to test another graphics card, because the camera is possible with the graphics card or display driver is not compatible.
Description: is likely to be with the 6326 4MB AGP graphics cards are not compatible. Perhaps the driver was not installed correctly (suggest that you reinstall the driver). If you use a popular chip SiS 6326 display card, it is prone to this problem. If you can not from the graphics card driver upgrade solve the problem, replace the display card only.
Q8 cameras installed after the installation of the cameras. From then on I do not know what equipment to use, and every time the camera or from the front of the camera to look at before we know which device is "service." How can set the default device?
A: intake of a video driver for the specific and effective methods are as follows:
Open "Control Panel", double-click "Multimedia" (Multimedia) icon.
Select "video", "device" (Device).
Open "video intake device" (Video Capture devices) list and double-click the name of PC-Camera, which opens a dialog box showing the attributes of the camera.
Drivers required to make effective. Because you selected a device, the device would allow the remaining void is impossible.
Description: When using a wide range of video equipment intake, the computer will use the default device. But it does not, as the printer equipment Win9x as easy to set the default printing device, there is no decision of the default installation method is more simple. Therefore, the best way is through a series of steps to select a.
Q9 use, the image in a pop-up box, there was black and white or black, how do?
A: Please refer to Notes in the Manual change the settings. Software may be in camera "Option" menu under "Preview" does not open, double-click and wait for 5-10 seconds.
Q10 original brand desktop computers can be used in a normal camera, connected to the notebook computer after normal use. Notebook computer with the conflict of what equipment you? And "Device Manager" there is no yellow symbols, how to do?
A: Please try to reduce the speed of graphics card. In the desktop, click the right mouse button, select "Properties", "Settings", "performance", the hardware-accelerated file from the No. 4 gradually reduced to the last file to see if you can solve the problem. If Yes, please a gradual increase in the grade until the problem can be solved to find the balance point.
Description: camera and display card most likely to conflict, after a problem occurs, in addition to the camera to find their own reasons, in the peripheral, the first graphics card to check.
How to hide their cameras this notebook?
Many bring their own notebook computers have built-in camera, but sometimes we do not want others to see our camera, then how should this notebook comes with a hidden camera built it?
Because the notebook comes with built-in camera is turned on automatically by default,
Compaq Presario V5000 Battery can record all the time in front of our notebook action. The software is through some foreign network can see other people's cameras. Therefore, in the long term is open camera, it is very dangerous. So if we want to shut down this laptop's built-in hidden camera, should we do?
First of all, the simplest is to start the whole camera shut down. As long as the Device Manager to disable the related hardware. Right-click "My Computer" Select Device Manager / management, to find a specific model camera hardware (which can be seen in the laptop manual, or search the Internet camera models can be), will double-click the camera equipment. And then the drop-down menu below to select the device to disable it. If you want to resume again, as long as here can be re-opened.
For just like in the QQ in the hidden camera, do not want to show the QQ camera can be set up through the completion of QQ. QQ click Settings, found in the personal settings display state, in the not to be included in the list of online video users check box in front of you. QQ on the people never see a camera